National Instruments NI cRIO-9118 - two ways of downloading and installing the driver

NI cRIO-9118 is a NI RIO Devices device. The Windows version of this driver was developed by National Instruments. The hardware id of this driver is PCI/VEN_1093&DEV_73FB.

1. How to manually install National Instruments NI cRIO-9118 driver

1. Download the setup file for National Instruments NI cRIO-9118 driver from the link below. This download link is for the driver version 22.8.0.49317 dated 2022-10-02.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver was installed by many users and received an average rating of 3.6 stars out of 72869 votes.

2. The easy way: using DriverMax to install National Instruments NI cRIO-9118 driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the National Instruments NI cRIO-9118 driver. Click on Update.
4.  
5. Finished installing the driver!
6.