Driver for National Instruments NI SMBus Controller - downloading and installing it

NI SMBus Controller is a NISMBusCont device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_8086&DEV_27DA&SUBSYS_FE701093.

1. National Instruments NI SMBus Controller - install the driver manually

1. You can download from the link below the driver installer file for the National Instruments NI SMBus Controller driver. The archive contains version 23.5.0.49275 dated 2023-07-05 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3 stars out of 80470 votes.

2. Using DriverMax to install National Instruments NI SMBus Controller driver

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the National Instruments NI SMBus Controller driver. Click the Update button.
4.  
5. Finished installing the driver!
6.