Driver for OWC NEC PCI to USB Enhanced Host Controller - downloading and installing it

NEC PCI to USB Enhanced Host Controller is a USB Universal Serial Bus device. The Windows version of this driver was developed by OWC. PCI/VEN_1033&DEV_00E0&SUBSYS_10741838 is the matching hardware id of this device.

1. Manually install OWC NEC PCI to USB Enhanced Host Controller driver

1. Download the setup file for OWC NEC PCI to USB Enhanced Host Controller driver from the link below. This is the download link for the driver version 2.00.0005.1 dated 2002-07-15.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 4 stars out of 52373 votes.

2. How to use DriverMax to install OWC NEC PCI to USB Enhanced Host Controller driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the OWC NEC PCI to USB Enhanced Host Controller driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.