Realtek N0U1 - two ways of downloading and installing the driver

N0U1 is a Network Adapters hardware device. The Windows version of this driver was developed by Realtek. The hardware id of this driver is USB/VID_17AA&PID_6117&REV_3000.

1. Realtek N0U1 - install the driver manually

1. Download the driver setup file for Realtek N0U1 driver from the link below. This is the download link for the driver version 11.03.20.1001 dated 2021-10-01.
2.  
3. Run the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

Realtek applied a digital signature to this driver.
Download size of the driver: 621558 bytes (606.99 KB)
This driver received an average rating of 4.1 stars out of 69171 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install Realtek N0U1 driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Realtek N0U1 driver. Click on Update.
4.  
5. Finished installing the driver!
6.