Hamrick Software Microtek ScanMaker s400 - two ways of downloading and installing the driver

Microtek ScanMaker s400 is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_201c.

1. Install Hamrick Software Microtek ScanMaker s400 driver manually

1. Download the setup file for Hamrick Software Microtek ScanMaker s400 driver from the link below. This is the download link for the driver version 1.0.0.6 released on 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.3 stars out of 99148 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker s400 driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker s400 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.