Hamrick Software Microtek ScanMaker s400 - two ways of downloading and installing the driver

Microtek ScanMaker s400 is a Imaging Devices device. The developer of this driver was Hamrick Software. USB/Vid_05da&Pid_201c is the matching hardware id of this device.

1. Install Hamrick Software Microtek ScanMaker s400 driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker s400 driver from the link below. This is the download link for the driver version 1.0.0.126 dated 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.7 stars out of 80449 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker s400 driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker s400 driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.