Hamrick Software Microtek ScanMaker i700 - two ways of downloading and installing the driver

Microtek ScanMaker i700 is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_2017.

1. How to manually install Hamrick Software Microtek ScanMaker i700 driver

1. Download the setup file for Hamrick Software Microtek ScanMaker i700 driver from the link below. This download link is for the driver version 1.0.0.142 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.4 stars out of 15526 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker i700 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker i700 driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.