Download and install Hamrick Software Microtek ScanMaker V6UPL driver

Microtek ScanMaker V6UPL is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_00ef.

1. How to manually install Hamrick Software Microtek ScanMaker V6UPL driver

1. Download the setup file for Hamrick Software Microtek ScanMaker V6UPL driver from the link below. This download link is for the driver version 1.0.0.137 released on 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver was not digitally signed.

Driver rating 3.6 stars out of 19873 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker V6UPL driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker V6UPL driver. Click the Update button.
4.  
5. Finished installing the driver!
6.