Hamrick Software Microtek ScanMaker V6UPL how to download and install the driver

Microtek ScanMaker V6UPL is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. The hardware id of this driver is USB/Vid_05da&Pid_00ef.

1. Hamrick Software Microtek ScanMaker V6UPL driver - how to install it manually

1. Download the setup file for Hamrick Software Microtek ScanMaker V6UPL driver from the location below. This is the download link for the driver version 1.0.0.136 dated 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

There is no digital signature available for this driver.

This driver was rated with an average of 3.4 stars by 7232 users.

2. How to install Hamrick Software Microtek ScanMaker V6UPL driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you find the Hamrick Software Microtek ScanMaker V6UPL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.