Hamrick Software Microtek ScanMaker V6UPL - two ways of downloading and installing the driver

Microtek ScanMaker V6UPL is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_00ef.

1. Manually install Hamrick Software Microtek ScanMaker V6UPL driver

1. You can download from the link below the driver installer file for the Hamrick Software Microtek ScanMaker V6UPL driver. The archive contains version 1.0.0.127 released on 2006-08-21 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is running please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.4 stars out of 52010 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker V6UPL driver

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker V6UPL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.