Driver for Hamrick Software Microtek ScanMaker V6UPL - downloading and installing it

Microtek ScanMaker V6UPL is a Imaging Devices device. This Windows driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_00b6.

1. How to manually install Hamrick Software Microtek ScanMaker V6UPL driver

1. Download the setup file for Hamrick Software Microtek ScanMaker V6UPL driver from the location below. This is the download link for the driver version 1.0.0.140 dated 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.4 stars by 99141 users.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker V6UPL driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker V6UPL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.