Driver for Hamrick Software Microtek ScanMaker V6UPL - downloading and installing it

Microtek ScanMaker V6UPL is a Imaging Devices device. This driver was developed by Hamrick Software. The hardware id of this driver is USB/Vid_05da&Pid_00b6; this string has to match your hardware.

1. Hamrick Software Microtek ScanMaker V6UPL - install the driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker V6UPL driver from the link below. This is the download link for the driver version 1.0.0.137 released on 2006-08-21.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.3 stars out of 19864 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker V6UPL driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker V6UPL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.