Hamrick Software Microtek ScanMaker V6UPL - two ways of downloading and installing the driver

Microtek ScanMaker V6UPL is a Imaging Devices device. This Windows driver was developed by Hamrick Software. USB/Vid_05da&Pid_00b6 is the matching hardware id of this device.

1. Hamrick Software Microtek ScanMaker V6UPL - install the driver manually

1. Download the setup file for Hamrick Software Microtek ScanMaker V6UPL driver from the location below. This download link is for the driver version 1.0.0.101 dated 2006-08-21.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.5 stars out of 87990 votes.

2. How to install Hamrick Software Microtek ScanMaker V6UPL driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker V6UPL driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.