Hamrick Software Microtek ScanMaker V6UPL - two ways of downloading and installing the driver

Microtek ScanMaker V6UPL is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. The hardware id of this driver is SCSI/Scanner________SCANNER_V6UPL___.

1. How to manually install Hamrick Software Microtek ScanMaker V6UPL driver

1. You can download from the link below the driver installer file for the Hamrick Software Microtek ScanMaker V6UPL driver. The archive contains version 1.0.0.127 dated 2006-08-21 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

This driver received an average rating of 4 stars out of 32357 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker V6UPL driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker V6UPL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.