Driver for Hamrick Software Microtek ScanMaker V300 - downloading and installing it

Microtek ScanMaker V300 is a Imaging Devices device. The Windows version of this driver was developed by Hamrick Software. The hardware id of this driver is SCSI/Scanner________SCANNER_600A4___; this string has to match your hardware.

1. Hamrick Software Microtek ScanMaker V300 - install the driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker V300 driver from the location below. This download link is for the driver version 1.0.0.132 released on 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.

Driver rating 3.2 stars out of 1637 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker V300 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker V300 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.