Hamrick Software Microtek ScanMaker III - two ways of downloading and installing the driver

Microtek ScanMaker III is a Imaging Devices hardware device. This driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is SCSI/ScannerMICROTEKSCANMAKERIII____.

1. How to manually install Hamrick Software Microtek ScanMaker III driver

1. Download the setup file for Hamrick Software Microtek ScanMaker III driver from the location below. This download link is for the driver version 1.0.0.6 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.2 stars out of 93788 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker III driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker III driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.