Hamrick Software Microtek ScanMaker III - two ways of downloading and installing the driver

Microtek ScanMaker III is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. The hardware id of this driver is SCSI/ScannerMICROTEKSCANMAKERIII____; this string has to match your hardware.

1. How to manually install Hamrick Software Microtek ScanMaker III driver

1. You can download from the link below the driver setup file for the Hamrick Software Microtek ScanMaker III driver. The archive contains version 1.0.0.140 released on 2006-08-21 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.6 stars out of 80316 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker III driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Hamrick Software Microtek ScanMaker III driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.