Hamrick Software Microtek ScanMaker III driver download and installation

Microtek ScanMaker III is a Imaging Devices hardware device. This driver was developed by Hamrick Software. SCSI/ScannerMICROTEKSCANMAKERIII____ is the matching hardware id of this device.

1. Install Hamrick Software Microtek ScanMaker III driver manually

1. Download the setup file for Hamrick Software Microtek ScanMaker III driver from the link below. This is the download link for the driver version 1.0.0.137 released on 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.2 stars out of 99882 votes.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker III driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker III driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.