Hamrick Software Microtek ScanMaker E3 how to download and install the driver

Microtek ScanMaker E3 is a Imaging Devices hardware device. This driver was developed by Hamrick Software. The hardware id of this driver is SCSI/Scanner________SCANNER_300A4___.

1. Install Hamrick Software Microtek ScanMaker E3 driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker E3 driver from the location below. This is the download link for the driver version 1.0.0.142 dated 2006-08-21.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver received an average rating of 3 stars out of 97851 votes.

2. Installing the Hamrick Software Microtek ScanMaker E3 driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker E3 driver. Click the Update button.
4.  
5. Finished installing the driver!
6.