Driver for Hamrick Software Microtek ScanMaker E3 - downloading and installing it

Microtek ScanMaker E3 is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is SCSI/Scanner________SCANNER_300A4___.

1. Manually install Hamrick Software Microtek ScanMaker E3 driver

1. You can download from the link below the driver installer file for the Hamrick Software Microtek ScanMaker E3 driver. The archive contains version 1.0.0.126 dated 2006-08-21 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was rated with an average of 3.7 stars by 59515 users.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker E3 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker E3 driver. Click the Update button.
4.  
5. Finished installing the driver!
6.