Hamrick Software Microtek ScanMaker E3 - two ways of downloading and installing the driver

Microtek ScanMaker E3 is a Imaging Devices hardware device. This driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is SCSI/Scanner________SCANNER_________.

1. Hamrick Software Microtek ScanMaker E3 driver - how to install it manually

1. You can download from the link below the driver installer file for the Hamrick Software Microtek ScanMaker E3 driver. The archive contains version 1.0.0.142 released on 2006-08-21 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was rated with an average of 3.3 stars by 96715 users.

2. Installing the Hamrick Software Microtek ScanMaker E3 driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker E3 driver. Click on Update.
4.  
5. Finished installing the driver!
6.