Download and install Hamrick Software Microtek ScanMaker 9700XL driver

Microtek ScanMaker 9700XL is a Imaging Devices hardware device. The developer of this driver was Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_20e0.

1. Hamrick Software Microtek ScanMaker 9700XL - install the driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker 9700XL driver from the link below. This is the download link for the driver version 1.0.0.136 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.9 stars out of 8269 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker 9700XL driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker 9700XL driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.