Download and install Hamrick Software Microtek ScanMaker 9600XL driver

Microtek ScanMaker 9600XL is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_208a.

1. Manually install Hamrick Software Microtek ScanMaker 9600XL driver

1. Download the driver setup file for Hamrick Software Microtek ScanMaker 9600XL driver from the location below. This is the download link for the driver version 1.0.0.136 released on 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.8 stars out of 7184 votes.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker 9600XL driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Hamrick Software Microtek ScanMaker 9600XL driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.