Download and install Hamrick Software Microtek ScanMaker 8700 driver

Microtek ScanMaker 8700 is a Imaging Devices device. The Windows version of this driver was developed by Hamrick Software. The hardware id of this driver is USB/Vid_05da&Pid_20b1.

1. Manually install Hamrick Software Microtek ScanMaker 8700 driver

1. You can download from the link below the driver setup file for the Hamrick Software Microtek ScanMaker 8700 driver. The archive contains version 1.0.0.140 dated 2006-08-21 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.2 stars out of 98864 votes.

2. Installing the Hamrick Software Microtek ScanMaker 8700 driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker 8700 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.