Driver for Hamrick Software Microtek ScanMaker 8700 - downloading and installing it

Microtek ScanMaker 8700 is a Imaging Devices hardware device. This driver was developed by Hamrick Software. USB/Vid_05da&Pid_20b1 is the matching hardware id of this device.

1. Hamrick Software Microtek ScanMaker 8700 - install the driver manually

1. Download the setup file for Hamrick Software Microtek ScanMaker 8700 driver from the location below. This download link is for the driver version 1.0.0.127 dated 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.8 stars out of 53134 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker 8700 driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the Hamrick Software Microtek ScanMaker 8700 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.