Hamrick Software Microtek ScanMaker 6700 - two ways of downloading and installing the driver

Microtek ScanMaker 6700 is a Imaging Devices hardware device. This driver was developed by Hamrick Software. The hardware id of this driver is USB/Vid_05da&Pid_20c9.

1. Hamrick Software Microtek ScanMaker 6700 driver - how to install it manually

1. You can download from the link below the driver setup file for the Hamrick Software Microtek ScanMaker 6700 driver. The archive contains version 1.0.0.3 dated 2006-08-21 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.5 stars out of 40753 votes.

2. How to install Hamrick Software Microtek ScanMaker 6700 driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker 6700 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.