Hamrick Software Microtek ScanMaker 5600 - two ways of downloading and installing the driver

Microtek ScanMaker 5600 is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_20a7.

1. Hamrick Software Microtek ScanMaker 5600 driver - how to install it manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker 5600 driver from the location below. This download link is for the driver version 1.0.0.137 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.4 stars out of 19716 votes.

2. Installing the Hamrick Software Microtek ScanMaker 5600 driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker 5600 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.