Hamrick Software Microtek ScanMaker 4700LP - two ways of downloading and installing the driver

Microtek ScanMaker 4700LP is a Imaging Devices device. The developer of this driver was Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_209e.

1. How to manually install Hamrick Software Microtek ScanMaker 4700LP driver

1. You can download from the link below the driver setup file for the Hamrick Software Microtek ScanMaker 4700LP driver. The archive contains version 1.0.0.132 released on 2006-08-21 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.6 stars out of 18970 votes.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker 4700LP driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker 4700LP driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.