Marvell Marvell FastLinQ Edge 10Gbit Network Adapter how to download and install the driver

Marvell FastLinQ Edge 10Gbit Network Adapter is a Network Adapters device. The developer of this driver was Marvell. The hardware id of this driver is PCI/VEN_1D6A&DEV_07B1&SUBSYS_7D031462&REV_02.

1. Install Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver manually

1. Download the setup file for Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver from the location below. This download link is for the driver version 3.0.19.0 released on 2021-01-22.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed by Marvell.
Size of this driver: 568707 bytes (555.38 KB)
Driver rating 4.7 stars out of 32804 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.