Marvell Marvell FastLinQ Edge 10Gbit Network Adapter how to download and install the driver

Marvell FastLinQ Edge 10Gbit Network Adapter is a Network Adapters device. The Windows version of this driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_07B1&SUBSYS_7C591462&REV_02.

1. Marvell Marvell FastLinQ Edge 10Gbit Network Adapter - install the driver manually

1. You can download from the link below the driver setup file for the Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver. The archive contains version 3.0.19.0 dated 2021-01-22 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by Marvell.
The file size of this driver is 568707 bytes (555.38 KB)
This driver was rated with an average of 4 stars by 32783 users.
This driver will work for the following versions of Windows:

• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you find the Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.