Download and install Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver

Marvell FastLinQ Edge 10Gbit Network Adapter is a Network Adapters device. This Windows driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_04C0.

1. Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver - how to install it manually

1. You can download from the link below the driver installer file for the Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver. The archive contains version 3.0.18.0 dated 2020-11-19 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 3 stars out of 33139 votes.

2. How to use DriverMax to install Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Marvell Marvell FastLinQ Edge 10Gbit Network Adapter driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.