LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller - two ways of downloading and installing the driver

LSI Logic MegaRAID SATA 300-4ELP RAID Controller is a SCSI Adapter hardware device. This Windows driver was developed by LSI Corp.. PCI/VEN_1000&DEV_0411&SUBSYS_20051000 is the matching hardware id of this device.

1. LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller - install the driver manually

1. You can download from the link below the driver setup file for the LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver. The archive contains version 6.600.23.00 dated 2013-04-17 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.2 stars out of 89537 votes.

2. How to install LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver. Click on Update.
4.  
5. Finished installing the driver!
6.