Driver for LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller - downloading and installing it

LSI Logic MegaRAID SATA 300-4ELP RAID Controller is a SCSI Adapter device. The Windows version of this driver was developed by LSI Corp.. The hardware id of this driver is PCI/VEN_1000&DEV_0411&SUBSYS_20051000.

1. LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller - install the driver manually

1. Download the driver setup file for LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver from the location below. This is the download link for the driver version 6.506.1.0 dated 2013-01-10.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.2 stars by 32136 users.

2. How to install LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.