Killer Killer e2200 Gigabit Ethernet Controller NDIS 6.30 - two ways of downloading and installing the driver

Killer e2200 Gigabit Ethernet Controller NDIS 6.30 is a Network Adapters hardware device. This driver was developed by Killer. The hardware id of this driver is PCI/VEN_1957&DEV_1091.

1. How to manually install Killer Killer e2200 Gigabit Ethernet Controller NDIS 6.30 driver

1. You can download from the link below the driver installer file for the Killer Killer e2200 Gigabit Ethernet Controller NDIS 6.30 driver. The archive contains version 8.0.2.40 released on 2012-12-03 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by Killer.
Download size of the driver: 102568 bytes (100.16 KB)
Driver rating 4.8 stars out of 70567 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Killer Killer e2200 Gigabit Ethernet Controller NDIS 6.30 driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Killer Killer e2200 Gigabit Ethernet Controller NDIS 6.30 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.