Realtek Killer E3000 2.5 Gigabit Ethernet Controller - two ways of downloading and installing the driver

Killer E3000 2.5 Gigabit Ethernet Controller is a Network Adapters device. This Windows driver was developed by Realtek. PCI/VEN_10EC&DEV_3000&REV_03 is the matching hardware id of this device.

1. How to manually install Realtek Killer E3000 2.5 Gigabit Ethernet Controller driver

1. You can download from the link below the driver setup file for the Realtek Killer E3000 2.5 Gigabit Ethernet Controller driver. The archive contains version 10.043.0723.2020 released on 2020-07-23 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

Realtek applied a digital signature to this driver.
Driver file size: 666882 bytes (651.25 KB)
This driver received an average rating of 4.2 stars out of 59545 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install Realtek Killer E3000 2.5 Gigabit Ethernet Controller driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Realtek Killer E3000 2.5 Gigabit Ethernet Controller driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.