SEGGER JLink CDC UART Port - two ways of downloading and installing the driver

JLink CDC UART Port is a Ports hardware device. The developer of this driver was SEGGER. The hardware id of this driver is USB/VID_1366&PID_1062&MI_02.

1. Manually install SEGGER JLink CDC UART Port driver

1. Download the driver setup file for SEGGER JLink CDC UART Port driver from the location below. This download link is for the driver version 1.34.0.44950 dated 2019-06-06.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is digitally signed by SEGGER.
Download size of the driver: 1878511 bytes (1.79 MB)
This driver received an average rating of 4.7 stars out of 87836 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install SEGGER JLink CDC UART Port driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the SEGGER JLink CDC UART Port driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.