Segger J-Link driver - two ways of downloading and installing the driver

J-Link driver is a USB Universal Serial Bus device. This Windows driver was developed by Segger. The hardware id of this driver is USB/VID_1366&PID_101B&MI_02.

1. Segger J-Link driver - install the driver manually

1. Download the setup file for Segger J-Link driver driver from the link below. This download link is for the driver version 2.6.8.1 released on 2014-07-28.
2.  
3. Run the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver received an average rating of 3 stars out of 99830 votes.

2. How to install Segger J-Link driver driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Segger J-Link driver driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.