Segger J-Link driver driver download and installation

J-Link driver is a USB Universal Serial Bus hardware device. The developer of this driver was Segger. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1366&PID_101A&MI_02.

1. How to manually install Segger J-Link driver driver

1. Download the driver setup file for Segger J-Link driver driver from the link below. This is the download link for the driver version 2.6.8.1 released on 2014-07-28.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is not digitally signed.

Driver rating 3.3 stars out of 99839 votes.

2. How to install Segger J-Link driver driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Segger J-Link driver driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.