Segger J-Link driver - two ways of downloading and installing the driver

J-Link driver is a USB Universal Serial Bus device. The developer of this driver was Segger. The hardware id of this driver is USB/VID_1366&PID_1016&MI_04.

1. Segger J-Link driver - install the driver manually

1. Download the setup file for Segger J-Link driver driver from the location below. This download link is for the driver version 2.6.8.1 released on 2014-07-28.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, it is as simple as that.
8.  

This driver was not digitally signed.

Driver rating 3.4 stars out of 99722 votes.

2. Installing the Segger J-Link driver driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Segger J-Link driver driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.