Segger J-Link driver driver download and installation

J-Link driver is a USB Universal Serial Bus hardware device. This driver was developed by Segger. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1366&PID_1015&MI_02.

1. How to manually install Segger J-Link driver driver

1. Download the setup file for Segger J-Link driver driver from the location below. This is the download link for the driver version 2.6.8.1 dated 2014-07-28.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.8 stars out of 99731 votes.

2. Installing the Segger J-Link driver driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Segger J-Link driver driver. Click the Update button.
4.  
5. Finished installing the driver!
6.