Segger J-Link driver - two ways of downloading and installing the driver

J-Link driver is a USB Universal Serial Bus hardware device. The developer of this driver was Segger. USB/VID_1366&PID_1014&MI_02 is the matching hardware id of this device.

1. Segger J-Link driver - install the driver manually

1. Download the driver setup file for Segger J-Link driver driver from the link below. This download link is for the driver version 2.70.08.0 released on 2018-08-02.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
The file size of this driver is 40666 bytes (39.71 KB)
This driver was rated with an average of 4.2 stars by 14867 users.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Segger J-Link driver driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Segger J-Link driver driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.