Segger J-Link driver how to download and install the driver

J-Link driver is a USB Universal Serial Bus hardware device. This Windows driver was developed by Segger. The hardware id of this driver is USB/VID_1366&PID_1013&MI_02.

1. Segger J-Link driver driver - how to install it manually

1. You can download from the link below the driver setup file for the Segger J-Link driver driver. The archive contains version 2.6.8.1 dated 2014-07-28 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.4 stars out of 99752 votes.

2. How to use DriverMax to install Segger J-Link driver driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Segger J-Link driver driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.