Segger J-Link driver - two ways of downloading and installing the driver

J-Link driver is a USB Universal Serial Bus device. The developer of this driver was Segger. USB/VID_1366&PID_1012&MI_02 is the matching hardware id of this device.

1. Segger J-Link driver - install the driver manually

1. You can download from the link below the driver installer file for the Segger J-Link driver driver. The archive contains version 2.6.8.1 released on 2014-07-28 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 3.8 stars out of 99761 votes.

2. How to use DriverMax to install Segger J-Link driver driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Segger J-Link driver driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.