Driver for Fresco Logic Generic USB Hub UN5010 Debug Mode - downloading and installing it

Generic USB Hub UN5010 Debug Mode is a USB Universal Serial Bus hardware device. The developer of this driver was Fresco Logic. USB/Vid_1D5C&Pid_0002&Rev_0100 is the matching hardware id of this device.

1. Fresco Logic Generic USB Hub UN5010 Debug Mode driver - how to install it manually

1. You can download from the link below the driver setup file for the Fresco Logic Generic USB Hub UN5010 Debug Mode driver. The archive contains version 1.0.100.00 dated 2021-02-26 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by Fresco Logic.
Size of this driver: 1717068 bytes (1.64 MB)
Driver rating 4.6 stars out of 92048 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Fresco Logic Generic USB Hub UN5010 Debug Mode driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Fresco Logic Generic USB Hub UN5010 Debug Mode driver. Click on Update.
4.  
5. Finished installing the driver!
6.