Driver for Fresco Logic Generic USB Hub FL5011 Debug Mode - downloading and installing it

Generic USB Hub FL5011 Debug Mode is a USB Universal Serial Bus hardware device. This Windows driver was developed by Fresco Logic. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_1D5C&Pid_5011&Rev_0100.

1. Manually install Fresco Logic Generic USB Hub FL5011 Debug Mode driver

1. You can download from the link below the driver installer file for the Fresco Logic Generic USB Hub FL5011 Debug Mode driver. The archive contains version 1.0.100.00 dated 2021-02-26 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by the manufacturer.
Download size of the driver: 1717068 bytes (1.64 MB)
This driver was rated with an average of 4 stars by 91848 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Fresco Logic Generic USB Hub FL5011 Debug Mode driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Fresco Logic Generic USB Hub FL5011 Debug Mode driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.