Fresco Logic Generic USB Hub CR5801S Debug Mode - two ways of downloading and installing the driver

Generic USB Hub CR5801S Debug Mode is a USB Universal Serial Bus hardware device. The Windows version of this driver was developed by Fresco Logic. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_2188&Pid_0034&Rev_0102.

1. How to manually install Fresco Logic Generic USB Hub CR5801S Debug Mode driver

1. Download the setup file for Fresco Logic Generic USB Hub CR5801S Debug Mode driver from the location below. This is the download link for the driver version 1.0.100.00 dated 2021-02-26.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

Fresco Logic applied a digital signature to this driver.
The file size of this driver is 1717068 bytes (1.64 MB)
This driver was rated with an average of 4.7 stars by 92984 users.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Fresco Logic Generic USB Hub CR5801S Debug Mode driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Fresco Logic Generic USB Hub CR5801S Debug Mode driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.