PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 how to download and install the driver

GW-USUltra300 MAC1 is a Network Adapters device. The Windows version of this driver was developed by PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4904&MI_01.

1. How to manually install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver

1. Download the setup file for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver from the link below. This download link is for the driver version 1027.0.0611.2014 dated 2014-09-01.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the updated driver, it is as simple as that.
8.  

There is no digital signature available for this driver.
File size of the driver: 1445960 bytes (1.38 MB)
This driver received an average rating of 3.3 stars out of 7127 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver. Click on Update.
4.  
5. Finished installing the driver!
6.