Download and install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

GW-USUltra300 MAC0 is a Network Adapters device. The Windows version of this driver was developed by PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4904&REV_0000&MI_00.

1. Manually install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

1. Download the setup file for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver from the link below. This download link is for the driver version 1027.4.0630.2015 dated 2015-10-08.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed by the manufacturer.
Download size of the driver: 1552974 bytes (1.48 MB)
Driver rating 4.1 stars out of 61306 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.