PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 - two ways of downloading and installing the driver

GW-USUltra300 MAC0 is a Network Adapters hardware device. The Windows version of this driver was developed by PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4904&MI_00.

1. How to manually install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

1. You can download from the link below the driver setup file for the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. The archive contains version 1026.12.0606.2014 dated 2014-06-30 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.3 stars out of 64518 votes.

2. Using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.