Driver for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 - downloading and installing it

GW-USUltra300 MAC0 is a Network Adapters hardware device. The developer of this driver was PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4904&MI_00.

1. Manually install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

1. You can download from the link below the driver installer file for the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. The archive contains version 1024.9.1219.2013 dated 2014-01-16 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

Driver rating 3.9 stars out of 24514 votes.

2. Using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.